Horizontal drilling
From Wikimarcellus
| Revision as of 02:26, 2 November 2008 Tcopley (Talk | contribs) ← Previous diff |
Revision as of 02:27, 2 November 2008 Tcopley (Talk | contribs) Next diff → |
||
| Line 7: | Line 7: | ||
| Reusable drilling rigs that cost up to $16 million apiece are generally used for horizontally drilling [[Marcellus shale]] wells. These rigs are larger-sized ones with 1,000 and 1,600 horsepower. | Reusable drilling rigs that cost up to $16 million apiece are generally used for horizontally drilling [[Marcellus shale]] wells. These rigs are larger-sized ones with 1,000 and 1,600 horsepower. | ||
| - | A business strategy sometimes employed is to drill a vertical well that can produce up to $700,000 per day in production. This can be done fairly inexpensively to get some science and good data about the acreage, and then go back later and do a horizontal portion to the well using a larger rig. | + | A business strategy sometimes employed is to drill a vertical well that can produce up to $700,000 per day in production. This can be done fairly inexpensively to get some science and good data about the acreage, and then go back in later to do a horizontal portion of the well using a larger rig. |
Revision as of 02:27, 2 November 2008
In order to tap natural gas with horizontal drilling typically a drill is sent down vertically a mile or so underground and then turned at a ninety degree angle horizontally into the shale. By using horizontal drilling the drill bit can penetrates a much greater number of pockets of natural gas than it ever could with vertical drilling. On the average horizontal wells produce three to five times the amount of natural gas from vertical ones.
The shale tends to be located between approximately five and eight thousand feet below ground.
Horizontal wells are much more expensive to drill than vertical ones. Costs may run between $4 million and $7 million U.S. for a horizontal shale well. Vertical ones can be drilled for only $1-2 million U.S.
Reusable drilling rigs that cost up to $16 million apiece are generally used for horizontally drilling Marcellus shale wells. These rigs are larger-sized ones with 1,000 and 1,600 horsepower.
A business strategy sometimes employed is to drill a vertical well that can produce up to $700,000 per day in production. This can be done fairly inexpensively to get some science and good data about the acreage, and then go back in later to do a horizontal portion of the well using a larger rig.
